Publicidad
Idiomas disponibles
Idiomas disponibles
4.1.2.3.3- Switching the pH adjustment on and off
To switch off or start-up the pH control again stopping the acid pump, access
the main menu, select "pH" in the last line. In the pH menu select the bottom
line. By pressing "OK", it alternatively passes from "pH ON" to "pH OFF".
When the pH control is off, the 3rd line of the screen displaying the parameters
indicates "pH OFF".
4.1.2.3.4- Priming the pump.
Once the acid pump has been installed, it should be primed to eliminate the
installation air.
Go to the "pH" menu and select "Manual". Keeping the "OK" button pressed,
the pump will be running. Keep the pump running with the "OK" button until
the liquid has passed throughout the tube until injection.
4.1.2.4- Clock
The equipment has a time clock, which will be taken as the reference when
programming times of the auxiliary relay. The clock keeps the time setting even
when the equipment is without supply.
4.2- Warning message and alarms
In the event of abnormal operation, the SMART series equipment will display an
alarm message on the 4th line of the screen, together with an acoustic warning.
The alarms shutdown the equipment until the problem is solved.
Similarly, it will display a warning also in the 4th line, but without an acoustic
signal or shutting down the equipment. In this case, the equipment can
continue operating, although you are informed that corrective action should be
taken.
4.2.1- Warning messages
Message:
"LACK OF SALT"
"EXCESS SALT"
Manual PRO v.1
Causes:
Lack of salt in the water.
Incrustations or objects in the
electrolysis cell causing excess
current.
The electrolysis cell is worn.
Excess salt in the water.
Incrustations or objects in the
electrolysis cell causing excess
current.
Action required:
Add salt to the swimming pool.
Clean the cell.
Replace the electrolysis cell with a
new one.
No action required if excess is not
very significant.
Clean the cell.
43 / 46
Publicidad
