SOLAC Turbobat Power 29.6V Instrucciones De Uso página 14

Downloaded by: pd-oliana on 19-04-2023 12:26 CEST
connector located in rear part above the handle.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 4 to 5 hours are needed for a
complete charge of the battery. Never attempt
to over-charge the battery (although it is
recommended that the first charge of the battery
be of 6 hours in duration).
- The pilot light will come on to indicate that the
charger is charging the battery.
- When the battery is charged disconnect the
charger from the mains supply.
- NB: Do not use the appliance while it is
connected to the charger.
HOW TO CHECK THE BATTERY'S CHARGE
LEVEL:
- Press the ON/OFF button (P), the pilot lights
that indicate if it is charged will light up.
- If all three pilot lights come on this means that
the appliance is fully charged.
- If no pilot light lights up, this means that the
battery is completely flat.
- NB: For a long battery life, it is advisable to
charge the battery, only, when it has run out
completely.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that product's packaging has been
removed.
- Before using this product for the first time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use:
USE:
- Turn the appliance on, by using the on/off
button.
- Select the desired speed pressing repeatedly
the speed selector (P). This function is very use-
ful, as it makes it possible to adapt the speed of
the appliance to the type of work that needs to
be done.
FITTING AN ACCESSORY TO THE HAND
VACUUM:
- The hand vacuum is designed in such a way
that it allows the following accessories to be
fitted: (use the combination that best meets your
requirements). (Fig.1).
USER MANUAL_AE2515.indb 14 USER MANUAL_AE2515.indb 14
- Furniture brush: Equipped with a brush at the
end, which brushes the surface as it is used.
- Crevice nozzle: Specially designed for getting
into cracks and difficult corners.
- We can insert the accessories into the tube.
(*) Press the button to bend the flexible tube
and access hard-to-reach areas. (Fig.7)
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Clean the appliance.
- Remove the battery and leave it in its battery
holder (Q).
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX: (FIG.2)
- Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced.
- First detach the extension tube by pressing the
button (O).
- Open the lid of the dust box press the button
to open the lower tank cover (L) located in the
front of the handle and empty the contents into
the appropiate waste disposal receptacle. (Fig.
2)
- Check the condition of the dust box filter.
CHANGING THE FILTERS:
- Dust tank HEPA filter (high efficiency air filter
that efficiently retains spores, ash, sawdust,
pollen...), it is advisable to change it a least
once a year or after every 50 hours of use, or if
its potency diminishes remarkably.
TO REMOVE THE FILTERS:
MOTOR FILTER: (FIG.3)
- Open the dust bin by pressing the dust tank
10/03/2023 13:40:00 10/03/2023 13:40:00