Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: The lower shoulder strap
clamp h as two spacer tabs attached.
These t abs are provided toadapt this
attachment
foruse with powerheads
that h ave a 1"diameter upper shaft
(the shoulder strap c lamp will n ot t ight-
endown s ecurely onthe1"diameter
upper shaft without using t hese
spacer tabs). The tabs must bebro-
ken off c ompletely
before use and
placed over t he screw holes o nthe
lower shoulder strap c lamp. These
tabs arenot n eeded forpowerheads
with a7/8" u pper shaft.
LOWER SHOULDER
STRAP
CLAMP
4_L.._ /
Spacer
Tabs
__"
positioned
for u se
k_'_ _
on1"diameter
upper shaft
1. Place t he upper shoulder strap
clamp over t he upper shaft above
thehandlebar.
2. Position thelower shoulder strap
clamp u nder the upper shaft and
align t heupper and lower clamp
screw holes (use spacer tabs be-
tween u pper and lower clamps if
necessary
tosecure clamp, i.e. f or
1"diameter
upper shaft).
POWERHEAD
END
Upper Shoulder
Clamp
j_
Ih
Lower Shoulder
• ATTACHMENT
Strap Clamp
_' END
Screws
3. Insert two screws into the screw
holes.
4.
Secure shoulder strap clamp by
tightening screws with the hex
wrench.
5.
Try on shoulder strap and adjust for
fit and balance before starting the
engine or beginning a cutting opera-
tion.
6.
Insert your right arm and head
through the shoulder
strap and al-
low it to rest on your left shoulder.
Make sure the danger sign is on
your back and the hook is to the
right side of your waist.
NOTE: A one-half twist is built in the
shoulder
strap to allow the strap to
rest flat on the shoulder.
7.
Adjust the strap, allowing the hook
to be about 3 - 6 inches below the
waist.
8.
Fasten the strap hook to the upper
clamp and lift the tool to the oper-
ating position.
," hou,der
"_/_
'_ Strap
IL4 "k I Clamp
,',
ADJUSTING
THE ASSIST HANDLE
'40&WARNING:
When adjusting
the
assist handle, be sure it remains di-
rectly above the coupler on the engine
end shaft to ensure proper balancing
of unit.
Assist Handle
Coupler
Publicidad
