EVGA SuperNOVA 850G Manual De Instrucciones página 6

Installation
3. Use the screws provided with your case to install the power supply into your
NOTE :
computer.
facing down. However, if your case places the power supply at the bottom of the
case and there are no ventilation holes available, it may be best to install the
power supply with the fan facing up for greater efficiency and reliability.
4. Connect the 24-Pin ATX cable to the PSU and the motherboard.
5. Connect the 4+4-Pin EPS12V cable to the motherboard.
plan on extreme overclocking
8-Pin or 4-Pin CPU power connectors,connect the second 4+4-Pin EPS12V
only
cable. This is needed for heavy overclocking or for Dual CPU motherboards.
6. Connect the 12VHPWR/6+2/6-Pin PCI-E cables to your graphics card(s).
NOTE 1 : Take extra care to fully plug-in the 12VHPWR cable to PSU and your
graphics card.
NOTE 2 : Avoid bending the 12VHPWR cable within 35mm of the 12VHPWR
connector.
NOTE 3 :
Do not attempt to plug an 8-Pin PCI-E cable into a 6-Pin connector
without first detaching the two extra pins.
NOTE 4 :
We recommend to use one PCI-E cable per PCI-E connector on your
graphics card if the card requires 2 or more PCI-E connections.
7. Connect SATA power cables to all data drives or optical drives (hard drives,
solid state drives, optical drives).
8. Connect the peripheral "Molex" 4-Pin connectors for fans, pumps, legacy
components and other devices/adapters.
9. Connect the AC power cord to your power supply and to the wall. Check all
connections to assure a solid connection and turn the power switch on the
power supply to the ON position.
It is recommended to install the power supply with the fan
and your motherboard supports additional
(Optional) – If you
04
35mm