Publicidad
Idiomas disponibles
Idiomas disponibles
Read these instructions and this manual
in its entirety before you attempt to
assemble or operate your new lawn
mower.
IMPORTANT: This lawn mower is
shipped WITHOUT OIL OR GASOLINE in
the engine.
Yournew lawn mower has been as-
sembled at the factory with the exception
of those parts left unassembled for
shipping purposes. All parts such as nuts,
washers, belts, etc., necessary to com-
plete the assembly have been placed in
the parts bag. To ensure safe and proper
operation of your lawn mower, all parts
and hardware you assemble must be
tightened securely. Use the correct tools
as necessary to ensure proper tightness.
TO REMOVE LAWN MOWER FROM
CARTON
1. Remove loose parts included with
mower.
2. Cut down two end comers ofsarton
and layend paneldown flat.
3. Remove all packingmaterials e xcept
paddingbetween upper and lower
handle and padding holding operator
presencecontrol b arto upper handle.
4. Roll lawn mower outofcarton and
check carton thorougly f oradditional
loose parts.
HOWTO SET UPYOUR
LAWN
MOWER
TO UNFOLD HANDLE
IMPORTANT:
Unfold handle carefully so
as not to pinch or damage control cables.
I. Raise lower handle section to
operating position and squeeze the
bottom ends of lower handle towards
each other until the pin in handle can
be inserted Into one of the three
height adjustment holes.
2. Remove protective padding, raise
upper handle section into place on
lower handle and tighten both handle
knobs.
3. Remove any packing matedal from
around control bar.
Your handles may be adjusted for your
mowing comfort. Refer to Service and
Adjustments section of this manual.
con_ol bar
Mowing
position
Lower handle
Squeeze_1_.(_._
Handlepin
3-Position
J
handle
bracket
TO INSTALL AI"rACHMENTS
Your lawn mower was shipped ready to
be used as a mulcher. To convert to
bagging or discharging, see "1"OCON-
VERT MOWER" in the Operation section
of this manual.
5
Publicidad
