Publicidad
Idiomas disponibles
Idiomas disponibles
ADDING
FUEL
WARNING:
Fuel and its vapors are extremely
flammable
and
explosive.
Fire or explosion
can cause severe burns or death.
When Adding Fuel
• Turn engine off and let engine cool at least 2 minutes before
removing the fuel cap.
• Fill fuel tank outdoors or in well-ventilated area.
• Do not overfill fuel tank. To allow for expansion of the fuel, do
not fill above the bottom of the fuel tank neck.
• Keep fuel away from sparks, open flames, pilot lights, heat,
and other ignition sources.
• Check fuel lines, tank, cap, and fittings frequently for cracks or
leaks. Replace if necessary.
. If fuel spills, wait until it evaporates before starting engine.
1. Clean the fuel cap area of dirt and debris. Remove the fuel
cap (G, Figure 3).
2. Fill the fuel tank with fuel. To allow for expansion of the fuel,
do not fill above the bottom of the fuel tank neck.
3. Reinstall the fuel cap.
START
THE ENGINE
Be sure that engine oil is at FULL mark on the oil fill cap/dipstick.
The snowthrower engine is equipped with an AC electric starter
and recoil starter. Before starting the engine, be certain that you
have read the following information.
If engine floods, set the choke to the OPEN/RUN position and
crank until the engine starts.
Start the engine as follows:
1. Check the oil level. See the Check/Add
Oil section in the
Engine Manual.
2. Make sure equipment drive controls are disengaged.
3. Push the ON/OFF switch (A, Figure 8) to the ON position.
WARNING:
The electric
starter
is equipped
with a three-
wire power
cord and plug designed
to operate
on AC
household
current.
The power
cord
must
be properly
grounded
at all times to avoid
the possibility
of electric
shock
which
can cause
injury
to the operator.
Follow
all
instructions
carefully
as set forth:
Make sure your
house
has a three-wire
grounded
system.
If you are not sure, ask a licensed
electrician.
If your
house
does
not have a three-wire
grounded
system,
do
not use this electric
starter
under
any condition.
If your
house
has a three-wire
grounded
system
but
a three-hole
receptacle
is not available
to connect
the
electric
starter,
have a three-hole
receptacle
installed
by
a licensed
electrician.
_
WARNING:
To connect
power
cord,
always
connect
the
power
cord
first to the switch
box located
on the engine
and then
plug the other end into a three=hole
grounded
receptacle.
_
WARNING:
To disconnect
the power
cord,
always
unplug
the end connected
to the three=hole
grounded
receptacle
first.
Starting Engine
Figure 8
16
Publicidad
