Descargar Imprimir esta página

Craftsman professional 333170 Manual Del Operador página 4

Ocultar thumbs Ver también para 333170:

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY I NSTRUCTIONS
1.
Remove Bag Frame [B] from Backing Plate [F].
2.
Using (2) 1/4-20 x 5/8 Pan Head Screws [J] and 2
Internal Tooth Washers [I], attach two Struts [A] into
frame as shown below in Figure 3.
Struts.
Figure 3
,
Bolt
Handle
Internal Tooth
Hole
Washer
Figure 5
Install Chute Mounting Bracket [G] to Backing Plate
[F] using (2) 3/8-16 x 1.00 bolts [P], (4) 3/8 Flat
Washers [Q] and (2) 3/8-16 Nylock nuts [R] as
shown below in Figure 6.
,
Install the Cloth Bag [H] to Bag Frame [B]. Attach
the "J" strip of the bag to the frame using a flatblade
screwdriver to pry the strip as shown below in
Figure 4.
,
"J" Strip
Flatblade Screwdriver
Figure 4
Attach two handles [C] to Bag Frame assembly [B]
with four 1/4-20 x 1.00 capscrews [K], four Internal
Tooth Washers [I] and four 1/4-20 Nylock nuts [L].
Insert capscrew through washer and through hole in
handle and through bag (bag must be cut to insert
bolt). Tighten nuts as shown in Figure 5.
,
Backing Plate
Chute Mounting Bracket
Figure 6
IMPORTANT: The two bolts and two washers go J
through Chute Mounting Bracket and Backing
J
Plate. Secure but do not tighten at this stage of
assemb y.
Attach Left [D] and Right Latch [E] to Backing Plate
[F] with four 10-32 x 5/8 Panhead Screws [M], and
four 10-32 Nylock nuts [N]. As shown in Figure 7 on
the next page.

Publicidad

loading