Publicidad
Idiomas disponibles
Idiomas disponibles
PanHead
Screw
Right L atch
Nut
Figure 7
I IMPORTANT: Do not tighten nuts completely, as I
Latches must slide up and down freely.
7.
Remove Chute Deflector from the mower deck by
removing (2) 3/8-16 nuts from the chute bracket
and save for future usage.
[_k,
DANGER:
Do not operate mower
without the grass collector installed. If the
grass collector kit is removed the chute
deflector must be installed.
8.
Remove chute baffle from the mower deck. This
part will be reinstalled in the next step with the new
baffle and hardware provided. See Figure 8.
,
Bolt
Attach Chute Baffle [S] and chute baffle previously
removed in step 8 to the inside of the mower deck
using (1) 5/16-18 x 1.00 bolt [T], (1) 5/16 Flat
Washer, and (1) 5/16-18 Nylock nut.
See Figure 9 below.
Nut
Washer
Chute Baffle
Chute Baffle
Figure 9
10. Using (2) 3/8-16 x 1.25 bolts [0] and (2) 3/8-16
Nylock nuts [R], attach backing plate [F] to the unit
as shown below in Figure 10.
Chute
Mounting
Bracket
Washer
_
e_
Chute Baffl
Bolt
Nut
Figure 8
Figure 10
Nut
Bolt
5
Publicidad
