DeWalt DW622 Traducido De Las Instrucciones Originales página 29

OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING: Always move your router as
indicated in figure 8 (outer edges/inner
edges).
Proper Hand Position (fig. 11)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on either
plunge limiter (o).
Switching On and Off (fig. 9)
The lock-on/lock-off switch (a) is located in the
handle on the right-hand side. The router is normally
locked in the off position.
1. Switching on: press and hold down the switch
(bb) to unlock the tool and subsequently
squeeze the trigger (cc).
2. For continuous operation, press the switch
(bb) again.
3. Switching off: squeeze the trigger (cc) again.
WARNING: Loosen the plunge limiter
and allow the router carriage to regain
its rest position before switching off.
Using the Guide Bushes (fig. 7)
1. Secure the template to the workpiece using end
clamps.
2. Select and install an appropriate guide bush (z).
3. Subtract the diameter of the cutter from the
outside diameter of the guide bush and divide
by 2. This is the difference between template
and workpiece.
WARNING: If the workpiece is not thick
enough, place it on a piece of waste
wood.
Guiding Off a Batten
Where an edge guide cannot be used, it is also
possible to guide the router along a batten clamped
across the workpiece (with an overhang at
both ends).
Freehand Routing
Your router can also be used without any sort of
guide, e.g. for signwriting or creative work.
WARNING: Make shallow cuts only!
Use cutters with a max. diameter of
8 mm.
Routing with Pilot Cutters (fig. 2)
Where a parallel guide or guide bush are
inappropriate, it is possible to use pilot cutters (dd)
for cutting shaped edges.
Consult your dealer for further information on the
appropriate accessories.
These include collets (6–12 mm), a depth stop
for use in inverted position, finger jointing tools
for dovetail and finger jointing jigs, dowel jointing
templates, guide bushes (17–40 mm) and guide rails
in various lengths.
MAINTENANCE
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Cleaning the Dust Extraction
Column (fig. 10)
1. Remove the dust extraction plug or adaptor.
2. Remove the four screws (ee) in the bottom of
the router base (j).
3. Clean the dust extraction column.
4. Reassemble the parts in reverse order.
Lubrication
Your power tool requires no additional lubrication.
english
27