Electric Brake; General Maintenance - Ubermann UID04BRA Manual Del Operador

OPERATION
Led Grip Light
See Figure 5, page 13.
The LED light, located on the front of the tool base, illuminates
when either the switch trigger or grip light switch is depressed.
If the tool is not in use, the time-out feature will cause the light
to start fading and then shut off.
The LED light illuminates only when there is a charged battery
pack in the tool.
Using the Tool
See Figure 5 and 6, page 13.
NOTICE:
The tool is not designed to be used as a drill.
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts. Use of any
other part could create a hazard or cause product damage.
WARNING:
Always wear eye protection with side shields marked to comply
with ANSI Z87.1 or equivalent standard, along with hearing
protection. Failure to do so could result in objects being thrown
into your eyes and other possible serious injuries.
WARNING:
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning, performing any maintenance, or
when storing the tool.
WARNING:
Do not drive a screw where there is likely to be hidden wiring
behind the surface. Contact with a "live" wire will make exposed
metal parts of the tool "live" and possibly shock the operator.
If you must drive a screw where hidden wire may be present,
always hold tool by insulated gripping surfaces (handle) when
performing the operation to prevent a shock to the operator.
• Check the direction of rotation selector for the correct setting
(forward or reverse).
• Hold the tool with one hand.
• Place the bit on the screw head, bolt head, or nut and slowly
depress the switch trigger. Start the bit slowly for more
control.
• As the screw, bolt, or nut is driven, impacting will begin.

Electric Brake

The electric brake will stop the bit rotation after the operator
releases the switch trigger.

General Maintenance

Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and can be damaged by their use. Use clean cloths to
remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic
parts. Chemicals can damage, weaken or destroy plastic which
could result in serious personal injury.
9 — English