TONOR TW620 Guia De Funcionamiento página 11

As shown in above pictures:
1. ANT B
2. BAL B
3. MIX
Before using the device, take out the wireless receiver from the
package, and connect the following cables: firstly use the 6.35
audio cable to connect the receivers MIX's port and other audio
devices (speaker, amplifier, mixer, etc,). Secondly, erect the
antenna, and connect the power cable. Thirdly, check if
microphone is connected to the receiver successfully after turning
on the device.
1 2 3 4 5
4. DC IN
5. BAL A
6. ANT A
08
6