Publicidad
Idiomas disponibles
Idiomas disponibles
No sound for TW630 (The batteries of microphone have already
been installed, but one of the microphone has on sound.)
Please turn off the microphone which can work normally, then
you will find that the RF light on the receiver will not stay on but
flashes slowly.
Then, please follow the steps below to pair the microphone (no
sound) with the receiver.
Wireless Microphone ID Pairing Steps:
1. Make sure that the receiver and microphone are turned OFF.
2. Unscrew the microphone tail tube and install the batteries into
the mic's battery compartment.
3. Make sure that the microphone is OFF, press and hold the HI/LO
button 4 and the power button 2 simultaneously, do not release
them, until the microphone screen flashes quickly, then release two
buttons simultaneously.
4. Turn on the receiver's power button, wait for 5 seconds or so,
then press the HI/LO button 4 (on the microphone) once, until the
microphone screen becomes steady and no longer flashes, the RF
light on the receiver turns steady, indicating that the pairing is
successful.
5. Tum off the microphone, then tighten the microphone tail tube.
Pairing is now completed.
Received signal with noise or interference
Change to other channels;
Check if receiving distance exceeds the maximum range.
Microphone cannot be tumed on
Check if batteries are installed reversely;
Change to new batteries.
WARRANTY
TONOR provides 2 years of after-sales service, free replacement to
products that are NOT damaged resulting from accident,
alteration, misuse, negligence, or abuse. If exceeding 30 days of
Amazon return policy, you can still contact us through our Shopify
TONORMIC. We will serve you with full sincerity!
11
Publicidad
