Tribest slowstar SW-2020 Manual De Uso página 11

1. Insert the Pressure Plug (located at the bottom
of the Auger Housing) by inserting it into the
Pulp Outlet properly, as shown in the picture.
2/2a. Attach the Auger Housing or Auger
Housing for Mincer to the Main Body.
Rotate the housing clockwise towards
the Safety Switch Link.
3. Place the Juicing Screen into the Pulp Wiping
Assembly, then assemble the Pulp Wiping
Assembly with the Auger Housing. Assemble
the Auger Housing with the Pulp Wiping
Assembly by aligning the marks on each of
the units as shown in the picture.
4/4a. Place the Duoblade Auger into the center
of the Juicing Screen or Auger Housing
for the Mincer.
5. Assemble the Feeding Chute Assembly/Mincer Lid.
Match the marks on Feeding Chute Assembly/
Mincer Lid to the marks on Auger Housing/Auger
Housing for Mincer, then rotate the Feeding Chute
Assembly towards the mark on the Handle of Auger
Housing as shown on the picture.
CAUTION: Assemble the Feeding Chute Assembly
last. If the Feeding Chute Assembly is assembled
before the Auger Housing is assembled on the Main
Body, the Auger Housing and the Main Body cannot
be assembled.
6. Place the juice and pulp containers as shown in
the picture. Both containers look identical.
7. Plug the Power Cord into the power outlet.
HOW TO ASSEMBLE
1.
2.
Safety
Link
3.
4.
5.
6.
EN
2a.
Marks
4a.
7.
11