Publicidad
Idiomas disponibles
Idiomas disponibles
/
OPERATION PROCEDURE
12
6
3. Select the day to be set as "holiday" by depressing the
"DAY" switch.
Refer to 3. "Setting ON/OFF Time" for the indication of
the " " mark.
The right figure shows the case of selecting the day "Tuesday".
4. Depress the "HOLIDAY" switch, the "HOLI" indication is
turned on and the selected day is set as "holiday".
In the case that the selected day is not set as running day the
" " mark is turned off. The holiday setting is not available for
the day. (In case that all days of a week are selected, only
the running day is set as "holiday").
By depressing the "HOLIDAY" switch again, the holiday
setting is canceled.
5. Depress the "SET/MONITOR".
The "SET" indication is turned off and the control timer is
changed to the monitor mode.
In case of setting the present day as "holiday", the "holiday"
setting is available from that time and the schedule operation
is canceled until the next day. In that case, the same day after
a week is not "holiday".
CHECKING CONTENTS OF SETTING
1. Depress the "DAY" switch at the monitor mode (when the
"SET" indication is turned off), the " " mark moves and the
setting contents of the day with the " " mark is indicated.
The right figure shows the case of selecting the day "Tuesday".
CAUTION:
- The control timer has a built-in back-up
battery and the clock function is available
within 2 weeks in case of power failure.
If the power failure continues more than
2 weeks, set the present time again.
- The RUN indicator is turned on at ON
time and turned off at OFF time.
In case that that the indoor unit operation
is started or stopped by the remote
control switch or the central station used
together with the timer, the RUN
indicator is not changed.
- The flickering of the RUN indicator
shows the abnormal condition of
the Timer. Check to ensure that the
wiring connection and the setting of dip
switches are correct. In the case that
the RUN indicator is still flickered after
checking, contact your distributor or
dealer of HITACHI.
ATTENTION:
CAUTION:
- It may take approximately 15 seconds
to start (or stop) operation after ON time
(or OFF time) according to the controller
used together.
- The operation can not be started or
stopped during the setting mode condition.
After the completion of setting, set
the Timer at the monitor mode. (After
3 minutes with leaving the Timer at the
setting mode, the Timer is changed to
the monitor mode automatically.)
- In the case that the Timer is used with the
central station (PSC-5S), the setting by
the central station is required. Refer to the
"Installation & Operation Manual of Central
Station" for details.
Publicidad
