Publicidad
Idiomas disponibles
Idiomas disponibles
Read these
instructions
and this manual
in
its entirety
before
you attempt
to assemble
or operate
your new lawn mower.
IMPORTANT:
This lawn mower
is shipped
WITHOUT
OIL OR GASOLINE
in the
engine.
Your new lawn mower
has been assem-
bled at the factory
with the exception
of
those parts left unassembled
for shipping
purposes.
To ensure
safe and proper
operation
of your lawn mower,
all parts
and hardware
you assemble
must be tight-
ened securely.
Use the correct
tools as
necessary
to ensure
proper tightness.
All
parts such as nuts, washers,
bolts, etc.,
necessary
to complete
the assembly
have
been placed
in the parts bag.
TO REMOVE
LAWN
MOWER
FROM
CARTON
1.
Remove
loose
parts included
with lawn
mower.
2.
Cut down two end corners
of carton
Operator
I
and lay end panel down flat.
control bar
3.
Remove
all packing
materials
except
padding
between
upper and lower
handle
and padding
holding
operator
presence
control
bar to upper handle.
4.
Roll lawn mower
out of carton
and
check
carton thoroughly
for additional
UP
loose parts.
HOW TO SET UP YOUR
LAWN
MOWER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold handle
carefully
so
as not to pinch or damage
control
cables.
1. Raise lower handle section
to operat-
ing position
and align hole in handle
with one of the height
positioning
holes
in handle
bracket.
2.
Insert handle
bolt through
handle
and
bracket
and secure with knob.
3.
Repeat
for opposite
side of handle.
4.
Remove
protective
padding,
raise up-
per handle section
into place on lower
handle
and tighten
both handle
knobs.
5.
Remove
any packing
material
from
around
control
bar.
Your lawn mower
handle can be adjusted
for your mowing
comfort.
Refer to "AD-
JUST
HANDLE"
in the Service
and Adjust-
ments
section
of this manual.
MOWING
POSITION
Upper
handle
Handle
knob
Lower handle
Publicidad
