Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove wing nut f rom shield.
2. Insert bracket into slot a sshown.
3. Pivot shield u ntil bolt p asses
through hole inbracket.
4. Securely
tighten wing n ut o nto bolt.
Bracket
Slot.
Shield
Gearbox
Wing Nut
KNOW
YOUR
TRIMMER
READ THIS OPERATOR'S
MANUAL AND SAFETY
RULES BEFORE
OPERATING
YOUR
UNIT. Compare
the illustrations
with your
unit to familiarize
yourself
with the location
of the various
controls
and adjustments.
Save
this manual
for future
reference.
Fixed Line Trimmer
Head
_.__
Throttle
""_
Assist
Handle_
Lock-out
Bump Feed Trimmer Head
Shield
Shaft
Throttle
Trigger
!_
Muffler
/
Line Limiter
Blade
ON/STOP
Switch
Choke
Lever
Starter
Handle
ON/STOP
SWITCH
The ON/STOP switch is used to stop
engine. To stop the engine, push and
release the engine ON/STOP switch.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
THROTTLE
LOCK-OUT
The THRO-FFLE LOCK-OUT must be
pressed with the palm of your hand as
you grip the throttle handle before the
trigger can be used. This feature
prevents you from accidentally
squeezing the throttle trigger.
CHOKE
The CHOKE helps to supply fuel to the
engine to aid in cold starting. Activate
the choke by moving the choke lever to
the FULL CHOKE position. After the en-
gine attempts to start, move the choke
lever to the HALF CHOKE position. Once
engine has started, move the choke le-
ver to the OFF CHOKE position.
BEFORE
STARTING
ENGINE
,_/LWARNING:
Be sureto
read
the fuel information
in the safety rules
before you begin. If you do not under-
stand the safety rules, do not attempt
to fuel your unit. Call 1-800-235-5878.
FUELING
ENGINE
WARNING:
Remove fuel cap
slowly when refueling.
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good
Publicidad
