Pur Line CHE-340 Manual De Usuario página 14

WALL MOUNTING
1) This appliance is designed to be fixed to a wall at a minimum height of 300mm and the minimum distance
from the top of the heater to the ceiling should be 1000mm. The wall bracket must be fitted horizontally and
the cable routed to the bottom right of the heater.
2) A distance of 600mm from the bottom of the heater to the floor is recommended for optimum viewing of
the flame effect.
3) The mounting bracket is fixed on the back of heater. Unscrew the 2pcs of screws and remove the bracket
before installation.
1: Select the wall location where you want to hang your electric fireplace heater. Draw a horizontal line using a
level and mark 4 drill holes for the anchor screws.
NOTE: The holes for mounting of fireplace shall be level so that the fireplace can be mounted properly.
2: Drill 4 holes 8mm(0.3in) in diameter and 26mm(1.02in) deep on the marked locations. Install the wall
anchors into the holes and gently tap them into place with a hammer until the flange of wall anchor is flush
with the wall surface.
3: Secure the mounting bracket to the wall anchors using the 4 anchor screws.
Mount the fireplace on wall using the slots of the metal bracket at the back of the fireplace. Make sure that the
mounting bracket is completely engaged into the metal bracket at the back of the fireplace.
4: Secure the mounting bracket to fireplace using 2 mounting screws.
1
3
EN
2
4
12