Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Trouble
Probable Cause
Remedy
Unit will not run.
• Selected humidity level has
• Raise humidistat setting if
been established,
desired.
• No Power.
• Check 120 volt source for
power.
Unit will not shut off.
Unit will not dry out completely.
• Float retainer is positioned in
•
"Manual Dryout" position.
• Float is not free.
• A small amount of water
remains in cabinet when
water level indicator reads
FILL.
Slide link arm assembly
retainer to lowest position in
slot at back of cabinet. (See
page 7).
Free float from obstruction.
Position float assembly
in
"Manual Dryout" position.
(See page 7).
Unit is not emptying
during
• Dirty filters.
• Change to fresh new filters.
use.
Water runts out of rear of unit.
• Water splashing
during filling.
•
Water level gauge not
functioning properly.
• Filters interfering with float.
•
Deflect fill water off the center
of the splash guard.
Do not overfill past "Full" label
in cabinet.
Be sure filters are positioned
properly in bottom of cabinet.
(See page 9).
CAUTION:
Use only 32-14900
EPA Registered Bacteriostat available from Sears Retail store.
Use of other water treatment
products may damage the filter elements.
Under no circumstances
should you use water treatment products designed for Roto belt or
Ultrasonic humidifiers.
13
Publicidad
