Medisana 88910 Instrucciones De Manejo página 20

88910_RBI_West_FINAL.qxd:Shiatsu-Massageauflage
GB
3 Operating
14
Use the buttons on control pad
• Switch on the device by pressing O
illuminates.
• When the "Upper Back" massage button
to the button illuminates and the Shiatsu massage heads
"Park" position at the base of the backrest, up to the shoulder area,
massaging the back in a circular motion whilst doing so. Once the uppermost
position has been reached, the direction of rotation of the massaging heads
is reversed. The heads then travel down to the centre of the back. Once the
heads reach this point, the direction of rotation is reversed again and then
travel up the back again. If you press button
function is switched off and the massage heads remain stationary in their
current position.
"Lower Back" massage button
• If you press the
the button illuminates. The Shiatsu massage heads
lower half of the back in a circular motion. The reversal of the direction of
rotation takes place when the respective end positions are reached. Pressing
button during the massage, switches off this function and the massage
heads remain stationary in their current position.
• If you press the "Full Back" massage button
similar to pressing buttons
• You can enhance the shiatsu massage at any time with a vibration massage
for your thighs by pressing the vibration massage button
• The vibration massage in the upper thigh area can be operated separately by
vibration massage button
pressing
vibration massage motors
illuminates and both
begin with a gentle massage. Press button
increases (medium intensity massage). Press button
vibration level increases (highest intensity massage). After button
a fourth time, the vibration massage is switched off and the green LED next
to the button extinguishes.
• The heat function can be activated at any time with the shiatsu massage,
during which the vibration massage can also be activated. Press the infrared
heat button to activate the function; the red LED lights up. The heat is
radiated through the massage heads
activate the heat function; the red LED goes out.
• To switch off the device: Press the
begins
to flash and the massage heads travel back down to the "Park"
position. When this position is reached, the blue LED extinguishes. If you press
the On/Off button when one of the massage functions is switched on, the
vibration motors just stop immediately. First the massage heads travel
downwards to the "Park" position. The blue LED flashes meanwhile and then
extinguishes.
• After each use, switch the device off using the O
the plug from the mains socket. Always store control pad
27.08.2009 8:21 Uhr
to operate the massage seat cover:
n/Off button . The blue power LED
is pressed, the green LED next
during the massage, this
, the green LED next to
travel up and down the
the function procedure is
and , except that it is for the entire back.
. The green LED next to the button
are switched on. They
again and the vibration level
a third time and the
. Press the button
On/Off button
. The blue
n/Off switch
Seite 14
move from the
.
is pressed
again to de-
power LED
and remove
in its bag .