GMC GDD12 Manual Del Usuario página 57

Note: If the Trigger Switch cannot be pressed down, check that the Forward/Reverse Switch
(5) is not set to its middle position, which locks the device (see 'Direction control')
3. The speed of the Impact Driver is controlled by the movement of the trigger: the
further the Trigger Switch is pressed down, the faster the Impact Driver will run
4. Release the Trigger Switch to stop the machine
WARNING: If the power tool gets excessively hot in use, stop using the tool immediately and
allow to cool before continuing work. The cooling period can be reduced by operating the
Impact Driver at maximum speed with no load. Always make sure the Motor Vents (4) are
not blocked and do not allow dust to enter the body of the tool through the Motor Vents; dust,
especially metallic dust, may damage or destroy the tool.
Accessories
GB
A full range of accessories including various types of drill and screwdriver bits is available
from your GMC stockist. Spare parts can be obtained from toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the mains power supply, before carrying out
any maintenance/cleaning of the charger. Remove the battery before carrying out any
maintenance/cleaning of the Impact Driver.
Note: Both the Impact Driver and the charger contain no user-serviceable parts. If the device
does not perform as outlined in this manual, return it to an authorised GMC service centre
for repair.
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should
be carried out by an authorised GMC service centre. This advice also applies to extension
cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly,
and shorten the machine's service life. Clean the body of your machine with a soft brush,
or dry cloth. If available, use clean, dry, compressed air to blow through the ventilation
holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol,
petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment
(WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose
of power tools
8