Orbegozo EV 3400 Manual De Instrucciones página 11

Envasadora al vacío
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EV 3400
4. Close the lid and press on both sides, vacuuming process starts, keep pressing by hands.
5. When it's vacuuming, green light blinks. When it's sealing red light blinks.
6. When process is finished, green light will be fixed, press unlock button to open the lid and remove the
bag with food well packed.
HOW TO USE FUNCTION SELECTOR
This button is used when you pack delicate food or food with liquid or in any other cases that pre-
sealing/immediate sealing is needed. While the vacuum sealer is vacuuming the bag, press the function
selector with thumb while the hands keep pressing both sides of lid. Then vacuum sealer stops vacuuming
and start sealing the bag, red light will blinks. When light is fixed sealing is finished.
CARE AND CLEANING
1. Always unplug the appliance before cleaning.
2. Do not immerse it in water.
3. Do not use abrasive products for cleaning.
4. Clean outer surface with soft damp cloth with soap and water.
5. To clean inside surface use paper towel to wipe away any food.
6. Dry all parts thoroughly before to plug and use it again.
7. Liquids may remain in vacuuming area which drawn from the bag before sealing. Clean them with soft
damp cloth with warm soap water and dry it immediately.
8. While you are not using the vacuum sealer keep the lid unblock.
TROUBLE SHOOTING
Nothing happens when I press both side of the lid to make vacuum.
- Ensure the power cord is correctly plugged into electrical outlet.
- Check the cord is not damaged.
- Ensure the plug is workable.
- Make sure the bag is placed correctly in vacuuming area.
- If you have used it a lot, wait 25 minutes to cool down the appliance and try it again.
Air is not vacuumed from the bag.
- Check there are not holes, folds or other fails in the bag.
- Check there are not cracks or worn areas.
- Foods with high liquid can be difficult to pack, drawn a bit the liquid before vacuuming.
- Check if the bag is well placed in vacuuming area.
Bag melts.
- Sealing bar can be very hot after several uses, let it cool down for 20 seconds between each use. if bag
keeps melting let the appliance cool down for 25 minutes.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido