Akai EA-G90 Manual Del Usuario página 4

CONNECTIONS
@When using the tape jack of an integrated amplifier
Integrated Amplifier
| Power Cable
To the AC outlet of an
integrated amplifier or
a household AC outlet
LINE OUT LINE IN
Turn off all the component before connecting.
Plug in the pin plugs of the connection cords firmly into the cor-
responding jacks.
Be careful not to mix the right and left channels or the input and
output jacks when connecting.
@ When using separate amplifiers
*
Amplifier
aanlpee ener)
een)
LINE OUT LINE IN
Since each switch of the EA-G90 may cause noise when operated,
do not conduct unnecessary switching operations during use.
The volume level cannot be continuously adjusted with EA-G90.
When using a separable integrated amplifier (one main and one pre-
amp section) or when using pre- and main amplifiers, refer to "When
using separate amplifiers".
When connected this way, the input levels to the tape deck can be
adjusted with the Volume Control of the pre-amplifier. To adjust
the output level from the tape deck, use the deck's output control.
When there are two sets of tape decks, use TAPE 1 jacks. ;
Plug in the power cord after making all the necessary Connections.