Genius INVICTUS X7 Instrucciones De Uso página 29

WARNING!
Risk of electric shock!
Switch the appliance off and disconnect it from the mains before cleaning or user
maintenance.
Never hold the appliance or accessories under running water or immerse them in
water or other liquids.
Clean the appliance by wiping it with a dry cloth.
„
Do not use harsh or abrasive cleaning agents or cleaning pads.
„
The accessories can be wiped with a damp cloth if necessary.
„
Emptying the dust container (see fig. S)
1. Hold the hand-held appliance over a dustbin and release the lock.
2. The flap will open and the dirt will fall out.
3. Close the flap again.
Removing/cleaning the dust container
1. Press the safety catch above the suction opening.
2. Turn the dust container clockwise to release the lock. (see fig. G)
3. Removing the dust container.
4. Empty the container and, if necessary, wipe it out with a dry or slightly damp cloth.
5. When putting the dust container back on, make sure that the lug on the lid is placed in the corresponding recess.
(see fig. H)
6. Turn the dust container anticlockwise until it audibly clicks into place.
Cleaning the filter
NOTE!
Only tap the HEPA filter to remove dirt - do not clean it with water. If the appliance is used regularly, replace
the HEPA filter every 6 months.
1. Opening or removing the dust container. (see previous section)
2. Turn the multi-cyclone filter clockwise to release the lock.
3. Remove the multi-cyclone filter.
4. The HEPA filter is located on the top of the multi-cyclone filter.
5. Remove the HEPA filter (see fig. I) and tap it out.
6. Clean the multi-cyclone filter with a brush or dry cloth. Rinse with clean water if necessary.
7. Allow to dry completely before reinserting.
8. Insert the HEPA filter into the multi-cyclone filter (see fig. J). Ensure it is correctly positioned. The HEPA filter must
be level, and the seal must not be squashed.
9. Insert the multi-cyclone filter into the hand-held appliance and tighten it anticlockwise.
10. Close or replace the dust container.
Cleaning the motorised electric brush:
1. Wipe the housing with a damp cloth.
Instruction manual
GB
29