Hitachi CSNET MANAGER XT Manual De Instrucciones página 9

Installation
3.2.2 Stand Mounted (Optional)
C A U T I O N
This device cannot built in neither installed without providing
ventilation to the aluminium sink behind.
CSNET Manager can be stand mounted by using any standard
VESA 75 mm stand mounted support for LT & XT and VESA 100
mm for XT only. HITACHI offers the following stand mounted
accessory VESA 75, model code 7E512301.
The stand comes disassembled in 2 parts:
4 screws
Base
1 Place the fixing screen support 90 degrees with respect to its
arm.
2 Put the screen upside down and insert the 4 stand screws on
the rear of the screen (the power source connector will be at
the bottom of the screen). There are 8 holes on the support, 4
for the LT screen and the other 4 for the XT screen.
Screws
3.3 CONNECTORS DESCRIPTION
Label Function
POWER Power on button
Compact Flash/ CF Type I/II Socket with
COM2 Ejector
COM1 Serial port 1 connector
LINE OUT Line-out audio jack
USB 2 x USB 2.0 connector
RJ-45 Ethernet connec-
LAN1
tor 1
3 PMML0303B rev.1 - 09/2014
Fixing
screen
support
Arm
Arm
Fixing screen
support
Screen
Note
Optional for 2nd
COM port
DB-9 male con-
nector
Dock USB
C A U T I O N
In order to avoid damage to the screen, protect it before setting
it upside down.
3 Screw the rear support screw to the arm and the stand will be
completely mounted.
Rear support screw
4 Finally, connect the power supply and LAN cable to the
CSNET Manager.
5 Press down the power switch.
6 CSNET Manager program starts automatically.
Label Function
LPC-1705/1707 -- PS/2
connector
KB/MS (LAN2)
LPC-17A4 -- LAN2
HDD HDD indicator
PWR System power indicator
CRT connector/HDMI
VGA/HDMI
connector
RESET Reset button
DC-IN DC Power-in connector
Note
For CSNET Man-
ager XT it is a
LAN2 (RJ-45 Eth-
ernet connector)