Descargar Imprimir esta página

Tru-Test Speedrite 500 Manual Del Usuario página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
Installing the energizer inside
The energizer must be installed inside when
being powered by the mains/line power supply.
Warning!
- Do not use a mains/line power extension
lead.
-
All countries except USA and Canada:
Allow 25 mm (1") of clear space around
the power adaptor.
To install the energizer inside:
1
Select a suitable installation site. See
Selecting a site for the installation
3.
2
Mount the energizer on a wall. Use the
template printed on the back cover of this
manual, if required.
3
Connect the Fence earth terminal (green)
to the earthing system.
4
Connect the Fence output terminal (red) to
the fence.
5
Connect the energizer to the mains/line
power using the mains/line power
adaptor.
Note:
If the energizer is being installed inside,
it may be powered by a battery, as an
alternative to the mains/line power supply.
4
Installing the energizer outside
The energizer may be installed outside,
powered by a battery. Battery leads may not be
supplied with the energizer, but may be
purchased as an accessory (Tru-Test part
number 811079P).
Warning!
Important safety instructions for Class 2
power units (USA/Canada only)
All other countries - Do not power the
energizer with mains/line power if it is being
installed outdoors.
on page
To install the energizer outside:
1
2
3
4
5
Note:
solar installation by connecting it to a battery
and solar panel(s). For information about solar
installations, refer to the product's website (see
packaging for details).
USA/Canada - Refer to
Select a suitable installation site. See
Selecting a site for the installation
3.
Hang the energizer on a fence wire or
mount the energizer on a post. Use the
template printed on the back cover of this
manual, if required.
Connect the Fence earth terminal (green)
to the earthing system.
Connect the Fence output terminal (red) to
the fence.
Connect the energizer to the battery using
the battery leads. Attach the + (red) clip to
the positive terminal of the battery, and
the – (black) clip to its negative terminal.
This energizer may be used as part of a
on page 11.
on page

Publicidad

loading

Este manual también es adecuado para:

0.5j mkii 5000.5j mkii x0.50.5j mkii 400