Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
SPECIFICATIONS
Occasional
care and maintenance
of the unit and the
software are needed to optimize the performance
of your
unit.
To clean the cabinet
Use a soft and dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution.
Do not use strong
solvents, such as alcohol, benzine or thinner as these could
damage the finish of the unit.
To clean
the heads
When the tape heads are dirty;
- high frequency
sound is not emitted
- the sound is not adequately
high
- the sound is off-balance
- the tape cannot be erased
- the tape cannot be recorded on
After every 10 hours of use, clean the tape heads with a
head cleaning cassette.
Use separately
sold dry-type or wet-type cleaning cassette.
Refer to the instructions
of the cleaning cassette for details.
Care of discs
.
When a disc becomes dirty, wipe the disc from the center
out with a cleaning cloth.
After cdavina a disc, store the disc in its case. Do not leave
the di'sc in ~aces that are hot or humid.
Care of tapes
Store tapes in their cases after use.
Do not leave tapes near magnets, motors, television sets,
or any source of magnetism.
This will downgrade
the
sound quality and cause noise.
Do not expose tapes to direct sunlight, or leave them in a
car parked in direct sunlight.
FM tuner section
Tuning range
87.5 MHz
to 108 MHz
Antenna
Rod antenna
AM tuner section
Tuning range
530
kHz to 1710 kHz (1 O kHz step)
531 kHz to 1602 kHz (9 kHz step)
Antenna
Ferrite bar antenna
Cassette
deck section
Track format
4
tracks, 2 channels stereo
Frequency
response
Normal tape: 50 Hz – 12500 Hz
Recording
system
AC bias
Heads
Deck 1: Recording/playback
head x 1
Erasure head x 1
Deck 2: Playback head x 1
Compact
disc player section
Laser
Semiconductor
laser (k= 780 nm)
D-A converter
1 bit dual
General
Power output
5
W + 5 W (4 ohms, EIAJ)
FTC rule
4 Watts per channel, Min.
RMS at 4 ohms from 65 Hz to
15,000 Hz, with no more than 1%
distortion
output
PHONES (stereo minijack)
Power requirements
DC 12 V using eight size D (R20)
batteries
AC 120V, 60 Hz
Power consumption
30 w
Dimensions
of main unit (W x H x D)
266 x 303x 278.5 mm
(101/2 x12xll
in.)
Weight of main unit
4.1 kg (9 Ibs. 1
OZ.)
Speaker
Type
120
mm cone type
27 mm ceramic type
Dimensions
(W x H x D)
198 x 303x 232 mm
(77/0 x12x
9 '/q in.)
Weight
1.75 kg (3 Ibs. 14
OZ.)
X
2
Impedance
4 ohms
Allowable
max. input
low
Specifications
and external appearance
are subject to
change without notice.
COPYRIGHT
Please check the laws on copyright relating to recordings
from discs, radio or external tapes for the country in which
the machine is being used.
16
ENGLISH
Publicidad
