Uebler P22 Instrucciones De Uso Y Montaje página 12

Basisträger_hoch.fm Seite 4 Dienstag, 8. März 2011 9:54 09
Attention
Only attach the bracket to the bicycle frame. Do not pinch
components such as shifting or brake cables.
Faulty clamps must be replaced immediately.
22
21
4
7
24 20
23
4. Attach the bracket (9) at a suitable location on the bicycle.
Tighten the clamp (21) with the rotary handle (22) and lock with
the key (4). Pull out the key (4).
5. Pass the lashing strap (20) between two wheel spokes, thread
into the buckles (23) and tighten (arrow) with the tensioning
lever (24).
Note
The threaded screws of the brackets must be cleaned and
lubricated at regular intervals to prevent the rotary handles from
freezing up.
Note
Tightening the lashing straps (20) places these under tension.
To loosen the straps, the latch (19) needs to be pressed firmly.
Mounting the second bicycle
The second bicycle is mounted in the same manner as the first.
Note that the bicycles are mounted in opposite directions.
The second bicycle is attached using the long bracket (10).
9
10
7
M+P-25A-0055
10
M+P-25A-0069
Mounting the third bicycle
2
The third bicycle is mounted in the same manner as the first. Note
that all bicycles are mounted in opposite directions to each other.
The third bicycle is attached to the second bicycle with an
additional bracket (2).
Tilting the bicycle rack back/forward
The bicycle rack can be tilted back away from the vehicle to load or
unload the vehicle.
Danger of injury!
Slowly tilt the bicycle rack back while ensuring that no persons
or objects are located in the tilting area.
There is a danger of crushing for people and objects in the tilting
area.
Ensure that the bicycle rack fully engages with both hooks and
locks when it is tilted forward. Otherwise, the bicycle rack could
tilt back during a trip and result in injury to you or others and/or
in property damage.
1. Hitch rack Uebler P32, for 3 bicycles
(order no. 15710)
- 4 -
1
M+P-25A-0070