Uebler P22 Instrucciones De Uso Y Montaje página 13

Basisträger_hoch.fm Seite 5 Dienstag, 8. März 2011 9:54 09
Tilting the bicycle rack back
25
Activate the foot lever (25) and tilt the bicycle rack (1) back by
pulling on the rack/bicycle frame.
Note
Only the bicycle racks Uebler P22, Uebler P32 and Uebler P22
+ expansion kit (order no. 19520) for max. 3 bicycles can be
tilted.
The bicycle rack Uebler P32 + expansion kit (order no. 19530)
for max. 4 bicycles cannot be tilted.
Tilting the bicycle rack forward
1
1. Tilt the bicycle rack (1) forward so that both hooks (26) are full
engaged in the frame (27) and locked.
2. Jiggle the bicycle rack (1) to ensure it is seated firmly.
If necessary, tilt the bicycle rack (1) back and forward again.
Preparations before driving
Danger of accident and injury!
All screw connections and attachments of the bicycle rack and
the bicycles must be checked before assembly, before every trip
and during lengthy trips to ensure they are firmly seated, and
they must be retightened if necessary. This measure must be
repeated at regular intervals regardless of the condition of the
road. In addition, the lighting system must be checked to ensure
it is working properly before every trip. If these instructions are
not followed, the bicycle rack together with the mounted bicycles
may come loose from the vehicle and cause injury to you or to
other persons, or may result in an accident.
Attention
The license plate and the lighting system of the bicycle rack
must not be covered.
1
M+P-25A-0056
If the bicycle is not fully loaded, it must ensured that:
• Brackets that are not in use are screwed closed and locked
• All keys are removed and stored
• The bracket for the third bicycle is stowed
• The lashing straps of all wheel rails are closed
Removing the bicycles
The bicycles are removed in the reverse order.
26
27
26
27
M+P-25A-0057
- 5 -