Uebler F14 Instrucciones De Montaje Y De Uso página 18

27 28 2 29
5
31
I
26
II
30
7. Place the bicycle on the wheel rails and position the clamp (28)
of the holder (2) on the bicycle frame. Secure the bicycle
against tipping.
8. Screw the clamp (28) to the bicycle frame with the twist grip (27).
9. Lock the holder (2) with the key (5) and remove the key (5).
10. Pass the lashing strap (26) centrally between two spokes,
thread into the buckle (30) and tighten.
Attention
Do not tighten the lashing straps (26) too firmly,
otherwise the tyres or rims could be damaged.
11. Use the tensioners (31) to tighten the lashing straps (26) (arrow I).
Note
The screw threads in the holders must be regularly cleaned
and greased to prevent the twist grips from seizing up.
Mounting the second bicycle
2
The second bicycle is mounted in similarly to the first.
Note that the bicycles are mounted in opposite directions.
Attention
Only attach the holder (3) to the bicycle frame, as other parts of
the bicycle could be damaged. Do not pinch components such
as gear or brake cables. Defective holders must be replaced
immediately.
The second bicycle is attached using the long holder (3).
Mounting the third bicycle
M+P-25A-0237
The third bicycle is mounted in the same way as the first.
Note that all the bicycles are mounted in opposite directions.
Attention
Only attach the holder (4) to the bicycle frame, as other parts of
the bicycle could be damaged. Do not pinch components such
as gear or brake cables. Defective holders must be replaced
immediately.
The third bicycle is attached to the second one with the additional
holder (4).
- 16 -
3
4
M+P-25A-0216
M+P-25A-0217