weasy swee32 Manual De Instrucciones página 10

2. Check to make sure the power ON/OFF button is in the (O) OFF position. Plug the
fully assembled Cotton Candy Maker into a 220-240V AC electrical outlet.
3. Press the power ON/OFF button to ON (丨) position. The extractor head will begin
to spin and the element will begin to heat.
4. When using hard candies, run the Cotton Candy Maker for 5 minutes to allow the
extractor head to preheat. When using granulated or superfine sugar, allow the Cotton
Candy Maker to run for 10 minutes to allow the extractor head to preheat.
5. After preheating, press the power ON/OFF button to (O)OFF.
CAUTION : After preheating, extractor head is hot! Avoid contact. Make sure the
extractor comes to a complete stop before adding candy or sugar 10 the extractor
head.
6. Place no more than 2 pieces of hard candy (Figure 3) or 1 scoop of granulated or
superfine sugar (1 tablespoon) into the extractor head (Figure 4). Make sure the hard
candies are evenly spaced. For a list of preferred candies or suggested flavor
combinations, see the "Hints For Best Results" section of this Instruction Manual.
Warning: To ensure the Cotton Candy Maker functions optimally, do not use more
than 2 pieces of hard candy or 1 scoop of granulated or superfine sugar at one time.
Overfilling the extractor head will clog the unit.
7. Press the power ON/OFF button to ON(丨)position. The extractor head will spin and
the element will begin to heat.
8. When the web of spun sugar fibers begin to collect around the bowl, slowly spin
the cone in your fingers while circling the bowl.
9. Once the cotton candy begins to collect on the cone, hold it horizontally over the
extractor
head and continue to spin the cone, moving from side to side. collecting all of the
candy from inside the bowl
WARNING : Do not leave the Cotton Candy Maker unattended when ON/OFF button
is ON (丨).