SNOWJOE sunjoe SWD5000 Manual Del Operador página 8

4. Three extension tubes are equipped with the unit.
If needed, insert the first extension tube into the vacuum
hose end, and press firmly to lock. Follow the same
instruction to assemble the second and third extension
tubes (Fig. 4).
Fig. 4
Extension tube
5. Select desired attachment, connect it with the end of the
extension tube, press firmly to lock securely. Your wet/dry
vacuum is ready for use (Fig. 5).
Fig. 5
Selected accessory
Operation
m
WARNING!
This equipment incorporates parts such
as switches, motors or the like that tend to produce arcs or
sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive
liquids or vapors, as electrical devices produce arcs or sparks
which can cause a fire or explosion – do not use at filling
stations or anywhere gasoline is stored or dispensed.
Starting + Stopping
Do not switch on the wet/dry vacuum until it has been
completely assembled. Before switching on the unit, always
check the power cord for signs of damage. Use only
intact cords.
m
WARNING!
Damaged cords pose a severe risk of injury.
Replace damaged cords immediately.
Vacuum hose
Extension tube end
m
WARNING!
Before switching on the wet/dry vacuum,
make sure that it is not in contact with any foreign objects.
1. Make sure the proper filter is installed before starting.
See page 10 to determine which filter to use.
2. Make sure the power head and the vacuum hose are
installed properly and locked securely.
3. Install the desired brush attachment onto the end of the
hose. Use the extension tubes if needed.
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the rating plate.
Plug the power cord into the outlet (Fig. 6). If an extension
cord is used, make a knot with the two cords as shown in
Table 1.
Fig. 6
5. To start the unit, press the ON/OFF switch on the ON(I)
position (Fig. 7), as indicated.
Fig. 7
6. To stop the unit, press down (O) on the ON/OFF switch,
as indicated (Fig, 7).
Operating Tips
This electric wet/dry vacuum is designed to clean hard
surfaces. It is only suitable for vacuuming wet or dry, light
materials. The vacuuming of heavy materials such as metal,
stones, branches, broken glass is expressly excluded.
m
WARNING!
Use the wet/dry vacuum only in daylight or
good artificial light.
• Make sure the power head is properly installed and
secured when using. Make sure each lock is secured.
Failure to properly secure the locks could cause the power
head to release from the tank.
8
Power cord
ON/OFF switch
ON (I)
OFF (O)