Publicidad
Idiomas disponibles
Idiomas disponibles
TO LEVEL
MOWER
Make
sure tires are properly
inflated
to
the PSI shown
on tires.
If tires are over
or under
inflated,
it may affect the appear-
ance of your lawn and lead you to think
the mower
is not adjusted
properly.
VISUAL
SIDE-TO-SIDE
ADJUSTMENT
1. With all tires properly
inflated
and if
your lawn
appears
unevenly
cut, de-
termine
which
side of mower
is cutting
lower.
2.
With a 3/4" or adjustable
wrench,
turn
lift link adjustment
nut (A) to the left to
lower
LH side of mower,
or, to the right
to raise
LH side of mower.
NOTE:
Each full turn of adjustment
nut will
change
mower
height
about
3/16".
Turn nut rig
to raise mower
Turn nut left
to lower mower
3.
Test your adjustment
by mowing
some
uncut grass
and visually
checking
the
appearance.
Readjust,
if necessary,
until you are satisfied
with the results.
PRECISION
SIDE-TO-SIDE
ADJUSTMENT
1. With all tires properly
inflated,
park
tractor
on level ground
or driveway.
CAUTION:
Blades
are sharp.
Protect
your hands
with gloves
and/or
wrap
blade
with heavy
cloth.
2.
Raise
mower
to its highest
position.
3.
At both sides of mower,
position
blade
at side and measure
the distance
(A) from bottom
edge of blade to the
ground.
The distance
should
be the
same on both sides.
4.
If adjustment
is necessary,
see step
2 in Visual
Adjustment
instructions
above.
5.
Recheck
measurements,
adjust
if nec-
essary
until both sides
are equal.
FRONT-TO-BACK
ADJUSTMENT
IMPORTANT:
Deck must be level side-
to-side.
To obtain the best cutting results, the
mower blades should be adjusted so the
front tip is 1/8" to 1/2" lower than the rear
tip when the mower is in its highest posi-
tion.
Ai_ CAUTION:
Blades are sharp. Protect
your hands with gloves and/or wrap blade
with heavy cloth.
• Raise mower to highest position.
• Position any blade so the tip is pointing
straight forward. Measure distance (B)
to the ground at front and rear tip of the
blade.
B
B
• If front tip of blade
is not 1/8" to 1/2"
lower than the rear tip, go to the front of
tractor.
• With an 11/16"
or adjustable
wrench,
loosen
jam nut A several
turns to clear
adjustment
nut B.
• With a 3/4" or adjustable
wrench,
turn
front
link adjustment
nut (B) clockwise
(tighten)
to raise the front of mower,
or,
counterclockwise
(loosen)
to lower
the
front
mower.
NOTE:
Each full turn of the adjustment
nut will change
mower
height
about
1/8".
•
Recheck
measurements,
adjust
if nec-
essary
until front tip of blade
is 1/8" to
1/2" lower than the rear tip.
• Hold adjustment
nut in position
with
wrench
and tighten
jam nut securely
against
adjustment
nut.
Tighten adjust nut
B to raise mower
Loosen adjust
nut B to lower
mower
24
Loosen jam nut A first
Publicidad
