Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
m_mWARNING:
Do not short battery ter-
als by allowing a wrench or any other
object to contact both terminals at the
same time. Before connecting
battery, re-
move metal bracelets, wristwatch
bands,
rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
1. Lift hood to raised position.
2. Disconnect
BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
3. Install new battery with terminals in
same position as old battery.
4. First connect RED battery cable to
positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
Slide terminal cover over terminal.
5. Connect
BLACK grounding
cable
to negative (-) terminal with remain-
ing hex bolt and keps nut. Tighten
securely.
6. Close hood.
H ex
Keps
Bolt _
Nut
Terminal
X
Cover
i "
TO REPLACE
HEADLIGHT
BULB
1.
Raise hood.
2.
Remove
bulb holder
from the hole in
the backside
of the grill.
3.
Replace
bulb in holder
and install
bulb
holder
securely
back into the hole in
the backside
of the grill.
4.
Close
hood.
iNTERLOCKS
AND
RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring.
See electrical wiring
diagram in the Repair Parts manual.
TO REPLACE
FUSE
Replace
with 30 amp automotive-type
plug-in
fuse.
The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD AND GRILL AS=
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor.
Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to re-
connect the headlight wire connector.
Negative
(Black)
Cable
Positive
(Red)
Cable
Headlight Wire
Connector
27
Publicidad
