Publicidad
Idiomas disponibles
Idiomas disponibles
How to Program
In order to perform each of the following six functions, the lock must first be placed in Programming Mode:
1. Press and hold EMTEK button for 3 seconds
2. Yellow LED flashes, then remains solid*,
number keys also illuminate
3. Enter Programming Code
If You Wish To
Change
Programming Code
(6 digits)
Add User Code
(4 digits)
(Store up to 20 User Codes)
Delete User Code
**Enable/Disable All User Codes
Delete All User Codes
Turn Beeper On/Off
*If no input within 20 seconds, Yellow LED goes out, Red LED flashes and lock exits Programming Mode.
**Also referred to as "vacation mode". This command temporarily disables all user codes (metal key override will still work).
10
Programming Your Lock
4. Yellow LED flashes, then 2 beeps
5. Yellow LED remains solid
Press Button
1
Enter New User
2
Enter User Code
3
4
5
6
(awaiting button press; see following table)
Actions
Enter New
Re-Enter New
Programming
Programming
Code
Code
(6 digits)
(6 digits)
Re-Enter New
Code
User Code
(4 digits)
(4 digits)
Re-Enter User
Code to be
to be Deleted
Deleted
Entering '4' disables all Users
(enables all if disabled)
Re-Enter Programming Code
Entering '6' turns OFF (or ON)
Indicators
• 1 Green LED flash
• 1 beep
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
• 1 beep
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
• 1 beep
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
Publicidad
