Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1
While holding Outside Trim
Plate Assembly, Press the
Plastic Extender (A) into end
of Spindle Shaft (B). The
Shaft is properly aligned
when the marking
'TOP' can be seen
from an overhead view.
STEP 2
Position the Outside Trim Plate Assembly through the bore hole.
!
Once positioned,
outside trim plate
assembly requires
support.
STEP 3
With the Outside Trim Plate Assembly flush to the door, REMOVE the Plastic Extender.
Install Outside Trim Plate Assembly
B
A
Feed wire harness
through the bore hole.
Fit Plastic Extender
through latch.
EN
!
This side
on top.
3
5
Publicidad
