Publicidad
Idiomas disponibles
Idiomas disponibles
CABINETS WITH DRAWERS
ASSEMBLY AND INSTALLATION
(IF YOUR UNIT DOES NOT HAVE DRAWERS CONTINUE
TO DETAIL AND FINISHING)
Place your folded drawer (I or K) on a flat clean area for
assembly. If you use the top of your cabinet to assemble the
drawer(s), please place a protective material on top of the
cabinet (like cardboard) to prevent scratching the top of the
cabinet.
Unfold the drawer sides so that it lays flat, remove the
drawer dividers and set aside. The food grade liner can stay
at the bottom of the drawer.
Start by folding up the back panel and 1 side panel, attach
the 2 panels by using 2 bolts (S). Finger tighten until both
bolts have been threaded in the nuts that have already been
welded into place.
Repeat on all panels until all 8 bolts (S) have been finger
tightened into place-tighten them with provided hex key (do
not over tighten).
When assembling the drawer front we recommend arranging
the drawer frame assembly so that the front is slightly over
the edge of your counter top or work surface. This will allow
the drawer handle to hang over the edge of the top of the
cabinet during assembly and allow the draw front to sit flat.
Have 1 person hold the corresponding drawer front to the
drawer (Medium drawer front L to Medium folding drawer K
or Large Drawer Front J to Large Folding Drawer I) in place
while attaching to the drawer frame by using 4 bolts (S), 2 on
each side of the drawer front. Finger tighten until all bolts
are in place. When bolts are all in place-tighten them with
provided hex key (do not over tighten).
If assembling the 3 Drawer unit assemble the remaining
drawers using above drawer assembly instructions.
8 | www.bluesk youtdoorliving.com
Publicidad
