Scheppach TIGER 2500 Traducción Del Manual De Instrucción Original página 30

Just in case.
Leather honing disc, profiled, order no. 8949 0705
For the inner side of finger-shaped tools.
16. Troubleshooting
Problem
Engine does not run.
The engine starts slowly
and does not reach the
operating speed.
Engine producing
excessive noise.
Engine does not reach
full power.
Motor overheats easily.
30 | GB
Possible cause
Engine, cable or connector
defective, fuses burnt.
Voltage too low, coils
damaged, capacitor burnt.
Coils damaged, motor
defective.
Circuits in the network are
overloaded (lamps, other
engines, etc.)
Overloading of the engine,
insufficient cooling of the
engine.
www.scheppach.com
Remedy
Have the machine checked by a specialist. Never
repair the engine yourself. Attention! Check the
fuses and replace them if necessary.
Have the power supply company check the voltage.
Have the engine checked by a specialist. Have the
capacitor replaced by a specialist.
Have the engine checked by a specialist.
Do not use any other devices or engines on the
same circuit.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum
engine cooling.