Publicidad
Idiomas disponibles
Idiomas disponibles
Slope Sheet
Keys
Key{s)
*installed
by Dealer
*Brush Guard Kit
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes.
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are tisted,
(1) 1/2" wrench
Tire pressure gauge
(2) 7/16" wrenches
Utility knife
Pliers
When right or left hand is mentioned in this
manual, _tmeanswhenyou areintheoperating
position (seated behind the steering wheel).
TO REMOVE TRACTOR
FROM
CARTON
UNPACK CARTON
•
Remove all accessible loose parts and
parts cartons from carton.
•
Cut along dotted lines on all four panels
of carton, Remove end panels and lay
side panels flat,
-
Check for any additional loose parts or
cartons and remove.
BEFORE
REMOVING
TRACTOR
FROM SKID
Label
TO ADJUST SEAT
•
Sit in seat,
•
Lift up adjustment lever (A) and slide seat
until a comfortable position is reached
which allows, you to press clutch/brake
pedal all the way down,
•
Release lever to lock seat in positio n.
TO CHECK BATTERY
1. Lift seat to raised position.
NOTE: tf this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of onehour at6-10 amps, (See
"BATTERY" in Maintenance section of this
manual for charging instructions).
°
For battery and battery cable installation
see "REPLACING
BATTERY" in the
"Service andAdjustments" section inthis
manual.
NOTE: You may now roll your tractor off
the skid, Follow the instructionsbelow to
remove the tractor from the skid,
WARNING: Before starting, read, un-
derstand and follow all instructionsin the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
7
Publicidad
