Publicidad
Idiomas disponibles
Idiomas disponibles
Read
these instructions and this manual in its entirety
before you attempt to assemble or operate your new lawn
mower° Your new lawn mower has been assembled at the
factory with the exception of those parts left unassembled
for shipping purposes.
All parts such as nuts, washers,
bolts, etc.,,necessary to complete the assembly have been
placed in the parts bag.
To ensure safe and proper
operation of your lawn mower, all parts and hardware you
assemble must be tightened securely_ Use the correct
tools as necessary to ensure proper tightness_
TO REMOVE
LAWN MOWER
FROM
CARTON
*
Remove loose parts included with mower.
=
Cut down two end corners of carton and lay end panel
down flat.
-
Remove all packing materials except padding between
upper and lower handle and padding holding operator
presence control bar to upper handle..
°
Roll lawn mower out of carton and check carton thor-
oughly for additional loose parts.
HOWTO
SET UPYOUR
LAWN MOWER
TO UNFOLD HANDLE (See Fig. 1)
IMPORTANT:
UNFOLD HANDLES CAREFULLY SO AS
NOT TO PINCH OR DAMAGE CONTROL CABLES,
•
Raise handles until lower handle section locks into
place in mowing position.,
°
Raise upper' handle section intoplace on lower handle,
remove protective padding and tighten both handle
knobs
•
Remove handle padding holding operator presence
control bar to upper handle.
•
Your lawn mower handle can be adjusted for your
mowing comfort.
Refer to "Adjust Handle" in the
Service and Adjustment section of this manual,,
NOTE: For' shipping purposes, the rear' wheels on your
lawn mower are not adjusted to the same position as the
front wheels. Before operating mower adjust all wheels to
the same cutting height position.
OPERATOR PRESENCE
CONTROLBAR
UPPER HANDLE
LIFT UP
MOWING POSITION
LOWER HANDLE
FIG. 1
MULCHER PLUG
FIG. 2
CAUTION; Do not run your lawn mower
without mulcher plug in place or ap-
proved clipping
deflector
or grass
catcher in place, Never attempt to op-
erate the lawn mower with the rear door
removed or propped open,
TO INSTALL ATTACHMENTS
(See Fig. 2)
Your lawn mower was shipped ready to be used as a
mulcher. To convert to bagging or discharging:
•
Open rear door and remove mulcher plug.
Store
mulcher plug in a safe place_
•
You can now install catcher or'optional clipping deflec-
tor.
•
To return to m_chingoperation,
instail mulcher plug
into discharge opening of mower° Be sure all tabs are
seated properly°
6
Publicidad
