Publicidad
Idiomas disponibles
Idiomas disponibles
• Insert one end of the line about 1/2
inch (1 cm) into the small hole inside
the spool.
• Wind the line evenly and tightly onto
the spool. Wind in the direction of the
arrow found on the spool.
• Push the line into the notch, leaving
3 to 5 inches (7 - 12 cm) unwound.
• Insert the line into the exit hole in the
hub as shown in the illustration.
• Align the notch with the line exit hole.
• Push the spool into the hub until it
snaps into place.
• Pull the line extending outside the
hub to release it from the notch.
Spool
Hub
Line exit hole
USER REPLACEABLE
SERVICE PARTS
REPLACEMENT PART
Spool with .065" Pro Trimmer Line
Assist Handle
Bolt Carriage, 1/4-20
Wing Nut
Shield Assy.
Edge Guide
Screw_10-16 X 1/2 HI-LO SEMS
PART NUMBER
71-85837
530-402657
530-401989
530-016152
530-402673
530-402661
530--015815
Prepare unit for storage at end of sea-
son or if it will not be used for 30 days
or more.
WARNING:
• Stop the unit and disconnectthe
power source when not in use.
• Carry the unitwith motor stopped.
• Store the unit so the line limiterblade
cannot cause injury.
• Store unit and extension cord in-
doors in a high, dry place out of the
reach of children. Store unit un-
plugged.
• Store unit with all guards in place.
Position unit so that any sharp object
cannot accidentally cause injury.
9
Publicidad
