Lindy 39383 Manual De Usuario página 6

User Manual
Receiver
1. SERVICE: USB Micro-B port for firmware update.
2. HDMI OUT: Connect to an HDMI display using an HDMI cable (not included).
3. AUDIO OUT: 3.5mm Audio output port for de-embedding audio signal.
4. CAT IN: Connect the receiver unit using a single Cat.6 or above cable for all data signals. Please do
not connect to a network port.
5. Data Signal LED (yellow):
- Illuminates when HDMI signal is with HDCP
- Flashes when HDMI signal is without HDCP
- Remains off when there is no HDMI signal
6. Link Signal LED (green):
- Illuminates when Transmitter and Receiver are connected
- Flashes when the connection between Transmitter and Receiver is poor
- Remains off when Transmitter and Receiver are not connected
7. KEYBOARD port: Connect a standard USB keyboard.
8. MOUSE port: Connect a standard USB mouse.
9. DC 12V: Connect the supplied 12V 1A power supply to an AC wall outlet and securely connector to
the Transmitter or Receiver. This is only required at one side of the installation.
Important! Before starting the installation, please ensure that all devices are powered off.
1. Connect an HDMI source device to the Transmitter unit using HDMI cable.
2. Connect one end of the Cat.6/7 cable to the CAT OUT port on the Transmitter and the other end to the
CAT IN port on the Receiver. U/UTP or F/UTP solid core installation cables are recommended. For
cable lengths please see the Specifications of this manual.
3. Use another HDMI cable to connect an HDMI display device to the HDMI output port on the Receiver
unit. Plug the DC power supply into the Transmitter or Receiver and switch on.
4. Power on the source device and display to complete the installation.
In addition to the installation steps outlined above, this Extender can also provide Audio de-embedded
signal from 3.5mm AUDIO OUT port on the Receiver. Connect a 3.5mm speaker or headphones to the
AUDIO OUT port if needed.
English