SETTING UP THE TRANSMITTER
Plate die transmitter near your television set or lo-fi system.
PUTTING THF TRANSMITTER INTO OPERATION
►
Use die supplied cable
10
connect socket Q on die TI 250
I
'IT 500
transmitter with die headphone socket on your television set
01
hi-fi
system.
NOTE
If your television set docs ixh have a headphone socket die sound signal can also
l*c taken from the SCART socket (video recorder socket). Please order die
suitable Sennheiser adaptor (Cut. no. 478/1! from your Sennheiser dealer,
Only for the IT 250 mono transmmci For television sets without any
suitable headphone sockets, the sound can also be taken directly from
the loudspeaker by using the Sennheiser MKE 100 TV microphone
(Cat. no. 03354). Connection to socket (T). This is supplied instead of
die headphone socket cable in the UK version).
► Connect the supplied plug-in mains unit to socket
(f>
on the TI 250 - TI
500 transmitter, then plug the mains unit into the mains.
LEVEL CONTROL OF THE TRANSMITTER
Adjust the volume of your hi li system or television sci to a middle position.
The IT 250 / TI 500 transmitter features an automatic modulation control
which prevents oveimodulation.
PUTTING THE RECEIVER INTO 0PFRATI0N
Insert die BA 151 accuplug into compartment
in the receiver.
Take special note of the instructions on accuplug
(ipcMtioii on pages
20.21
ol this manual'
(NB: The BA 151 accuplug must he charged for 2-1 hours before first use!)
SWITCHING ON THE RECEIVER
Use control
to switch on tin receiver and adjust the volume. An cllicicnt
volume compression system avoids die necessity of frequent volume adjustments.
It reproduces quiet sounds slightly louder and loud sounds slightly quieter.
ADJUSTING YOUR HI-FI SYSTEM
Read the instruction manual of your hi-fi system or television set to find out
whcdiei the volume control also works for die headphone socket, or whether
this socket has a separate volume control. The manual will also tell you how
to turn off the main loudspeakers.
I?