Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Step 8
Attach the reflector (A) to the radiation screen
LL
assembly using 3 M6x60 studs (KK), 3 M6 washers
(MM) and 3 M6 cap nuts (LL)� Tighten with the included
A
MM
wrench (HH)�
kk
Step 9
9
Remove the 3 preassembled screws from the upper
supports (K)� Place the reflector (A) onto the top
of the upper supports (K)� Replace the 3 screws
removed at the beginning of this step to secure the
A
reflector (A) to the upper supports (K)� Tighten with
a Phillips screwdriver�
K
Step 10
Carefully slide the glass tube (G) in between the upper
supports (K) and place on top of the glass tube ring (D)�
G
D
12
Publicidad
