ENGLISH
in the slide.
- Assembly: hold the sides of the door shelf with both hands. Install the clip on the
slot first. Then, push the other side slightly inwards–the clip will click into place on the
slot and the door shelf will be installed. Make sure the appliance is installed correctly
before using it. (Fig. 9)
Fig. 9 key:
1. Door-shelf slide
2. Door lining
3. Door shelf
Instructions for locking the water dispenser (Fig. 10)
- Push the child safety lock lever with your thumb as shown in Figure 10 (arrow 1)–the
lever (2, Fig. 10) will lock and it will, in turn, lock the water dispenser.
- Push it in the opposite direction to unlock the water dispenser.
Instructions for installing the water tank (Fig. 11)
- Grasp both sides of the tank with your hands and pull the tank assembly slightly
upwards out of the door.
- Turn the water valve assembly counterclockwise to remove it from the water tank
for cleaning.
- Move the tab on the water-tank cover slightly upwards to detach the water-tank
cover from the water tank. Lift the cover on the other side in the same way and clean
the tank and the cover.
- Install the water valve by turning it clockwise after cleaning. When installing the tank
cover, fit one side first (do not press down all the way), then the other side. Reinstall
the water tank assembly at 45 degrees to the door. Press the outer edge of the water
tank slightly downwards so that it clicks into the door.
Please note
- The transparent silicone parts of the water valve may come off while removing the
water tank. If it were the case, remove and reinstall them by following the steps below:
1. Align the valve piece with the hole in the door and push it in.
2. Once the piece fits tightly into the hole, installation will be complete.
Filling up the water tank (Fig. 12)
Open the water-tank inlet cover (1). Slowly fill the tank with water up to the maximum
filling limit marked "2L". Then, close the inlet cover (1). To avoid spillage, use a narrow-
36
EVVO FRIGORÍFICO FRANCÉS F80X / 80X AQUA / F80B GLASS