Descargar Imprimir esta página

Ventus KT001-18DR Manual De Instrucciones página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

1- ASSEMBLE THE MOVING
WHEELS
The product is equipped with 4
casters, which are placed in the
bubble of the outer packaging
box. After opening the product
packaging box, take the air cooler
out.You need to put it upside down
on flat ground or table and align
the iron shafts of the 4 casters with
it. The 4 caster holes at the bottom
are inserted firmly into place, and
then the product with assembled
casters can be used normally.
2- ADD WATER TO THE
CONTAINER AT THE TOP
Open the upper sink cover, and
using a cup or a bottle slowly pour
clean water into the middle of the
water tank. Note that the water
surface should not exceed the
square container area in the middle
of the water tank when adding
water to avoid overflow. The water
container can hold at most 8 liters
of water. The water volume should
not exceed the maximum water
level to avoid overflow of the
bottom water tank. In the process
of using the cool air function, pay
attention to the decrease of the
water tank water volume. When
the water volume is reduced to
the lowest water level, please add
water in time.
Do not shake the product while it's
full with water to prevent the water
in the tank from overflowing.
3-DRAIN THE REMAINING WATER
Once you are done using your
Ventus Cooling System, there is a
water drain at the bottom in order
to prevent water from being stored
in the water tank. When water
needs to be drained, it needs to
be moved to a suitable place, and
then the water drain lid has to be
removed. The remaining water
in the water tank will come out
through the drain hole outflow.
4- ADDING THE ICE BOTTLES
To enhance the cool air mode, put
the ice container in the refrigerator
till they freeze. Then place inside
the water tank of your Ventus
Cooling System.
Do not
fill past
the
edge.
7

Publicidad

loading