Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3. operating the wood chipper
It may be helpful to better familiarize yourself with the features of your Wood Chipper before beginning the steps outlined in this
chapter.
warning
A. Read and understand all instructions, safety precautions, and/or warnings listed in "General safety rules" before operating
the Wood chipper. If any doubt or question arises about the correct or safe method of performing anything found in this manual,
please contact the dealers in your area.
B. When operating the Wood chipper, make sure you are standing in the safe operating area. You must stay in the safe operating
area at all times when the ram is in motion (whether extending or retracting). Never place any part of your body into a position
that causes an unsafe operating condition.
C. Before loading and operating the Wood chipper, always wear protective gear, including safety goggles, hearing protection,
tight-fitting gloves without draw strings or loose cuffs, and steel-toed shoes.
D. Knowing the correct and incorrect methods of chipping woods. Never using an incorrect or unsafe method.
Starting
1. Position your Wood Chipper on flat, dry ground, and then stop the front wheel with brake, make sure the machine cannot be
moved.
2. Make sure the fuel shut-off valve is in the "ON" position.
3. Move the choke control lever to the "CHOKE" position (should only be needed if the engine is cold).
4. Move the throttle control lever to the "FAST" position.
5. Recoil Start: Turn the Ignition Switch to the "On" position. Grasp the recoil starter handle and slowly pull until you feel resistan-
ce. Let the cord retract a little bit then pull the cord rapidly to start the engine. One or two pulls usually starts the engine.
6. Electric start: If applicable, turn and hold the Key in the start position until Engine starts then let the Key return to run position.
7. Move the choke control lever (if used for cold engine) slowly back to the "RUN" position when the engine is running well.
8. If the Wood Chipper has not been running (cold engine), warm up the engine by running the engine at half throttle for 3 to 4
minutes, then advance the engine throttle control to the maximum speed.
Stopping
1. Move the throttle lever to IDLE.
2. Recoil start: Turn the ignition switch to the OFF position.
3. Electric start: If applicable, turn the key to the OFF position.
Operator zone
TOP VIEW
Foot plate
Engine
Operator zone
Infeed
Operator zone
7
Publicidad
