Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
FOLLOW ME FUNCTION
There is a temperature sensor built into the remote
control that will continuously collect the current
room temperature. Keep the remote control with
you and the appliance will automatically adjust the
set temperature based on the current temperature
where you are located to reach the most
comfortable condition and temperature.
Press the follow me button to activate the follow
me function. The remote will display the current
temperature at its location. The remote will send
a signal to the air conditioner every 3 minutes, so
long as you remain within range of the appliance.
The follow me light on the control panel of the
appliance will illuminate for 5 seconds every three
minutes to indicate that it has received a signal
from the remote. If the appliance does not receive a
signal from the remote during any 7 minute interval,
it will beep to indicate that the follow me mode has
ended.
The maximum distance for the follow me feature is
8 meters (26 feet). This feature is available in cool
and auto modes.
SLEEP FUNCTION
The sleep function can be used to conserve energy
during sleeping hours.
When selected, the set temperature will increase
by 1°C/2°F every half hour for one full hour. The
appliance will hold the new set temperature for
6 hours before automatically returning to normal
operation.
The sleep function can be canceled at any time by
pressing the sleep button.
SHORTCUT FUNCTION
The shortcut function can be used to save a favourite
setting.
To set a favourite, set the appliance to the desired
temperature and fan speed. Press and hold the
shortcut button for 2 seconds. Press the shortcut
button at any point in future to return to the
favourite setting.
If no favourite is set, pressing the shortcut button will
cause the appliance to run in auto mode at 29°C
(79°F), with fan speed set to auto.
The shortcut function is only available on the remote
control.
WIRELESS CONNECTION
This appliance can be controlled with a wireless
application on your wireless device.
Visit https://www.danby.com/support/apps to
download the application and learn about its
operation.
17
Publicidad
