Descargar Imprimir esta página

EuroLite LED RV-3X3 RGB Beam Effect Manual Del Usuario página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
Sound-control:
Maximum ambient temperature T
Maximum housing temperature T
Minimum distance from flammable surfaces:
Minimum distance to lighted object:
Fuse:
Number of 3W LEDs:
LED beam angle:
Dimensions (LxWxH):
Weight:
Please note: Every information is subject to change without prior notice. 20.05.2009 ©
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
:
a
(steady state):
B
230 V AC, 50 Hz ~
30 W
via built-in microphone
45° C
50° C
0.5 m
0.1 m
F 1 A, 250 V
3 (1xred, 1xgreen, 1xblue)
140°
285 x 250 x 255 mm
3 kg
16/29
00046976.DOC, Version 1.0

Publicidad

loading