Krups SAVOY ET351 Manual Del Usuario página 8

KR_CAFETIERE_ET351_NC00131758_Mise en page 1 10/09/15 09:57 Page10
■ We recommend removing the filter holder with the filter before adding the ground coffee. If you accidentally
pour ground coffee into the water tank, do not start the cycle. Clean the tank, otherwise the coffee may
block the water circuit.
■ Add 1 KRUPS spoon (v) of ground coffee per cup. Do not exceed 12 spoons (2 ounces). Fig. 12.
■ Close the lid (b).
■ Press the
BREW
started the brew cycle. The machine will beep once. Fig. 13.
■ At the end, your machine will beep 3 times and the
stop automatically a maximum of 5 minutes after the brewing cycle ends, i.e. 5 minutes after the reservoir
is completely empty.
■ Remove the thermal carafe from the coffee maker so that the coffee is kept hot in the best conditions
possible.
■ In order to pour coffee from the thermal carafe, press the lever on the lid. Fig. 19.
■ This thermal carafe can keep your coffee hot for up to 4 hours.
NB:
- The amount of coffee in the thermal carafe at the end of the cycle is less than the amount of water poured
into the tank because about 10% is absorbed by the ground coffee and the filter.
- There is an overflow hole on the back of the water tank. If you add too much water, it will leak out of this hole.
- To ensure maximum heat retention, rinse the thermal carafe with hot water before use and close the lid by
twisting it clockwise.
- Clean the permanent filter between each use or use a new paper filter.
CAUTION:
- To avoid any overflow, the thermal carafe must be properly positioned on the base of the coffee
maker, otherwise it could cause hot water or hot coffee to overflow.
- The coffee maker becomes very hot during the brew cycle. Please handle with care.
6. OTHER FEATURES
6a – AUTO START FUNCTION
Programming the auto-start settings.
■ Your appliance is equipped with auto-start program.
■ Check whether the clock is set to the right time. If not, follow the instructions in the SETTING THE CLOCK
section.
■ Press the AUTO ON (m) button. The AUTO icon will appear on the display. Figs 14-15-16.
■ Set the time by pressing the
Set the program by pressing
■ Starting a auto-on function when time has already been set.
- See the section MAKING COFFEE.
AUTO ON
- Press
■ To cancel the auto-start function, press twice the
6b – REGULAR OR BOLD
■ The BOLD function increases the cycle time for stronger coffee.
■ Press the BOLD (p) button to select the strength of your coffee. Fig. 17.
■ The BOLD button lights up (p).
■ The function is stored in the memory for subsequent cycles.
■ To cancel the BOLD function, press the BOLD button again.
6c – 1 - 4 CUPS
■ This function is specially designed for making small volumes of coffee, i.e. between 2 and 4 cups. It makes
it easier to extract optimal aroma and flavor.
■ To activate this function, press the
10
button (l). The BREW button light will come on to show that the coffee maker has
H
button (n) to set the hour and the
BREW
(l).
BREW
(l).
, then press
1 - 4
cups button (q) before starting the cycle. Fig. 18.
BREW
button (l) will turn off. Your coffee maker will
MIN
button (o) to set the minutes.
AUTO ON
button or press the
BREW
button.