Publicidad
Idiomas disponibles
Idiomas disponibles
VI. Advanced operation
Pairing the sound bar with your Bluetooth
Note: Before installing this product, please make sure your device is compatible
with Bluetooth
.
®
1. First turn on the soundbar by pressing the Power button
or on the remote control. Bluetooth
select the BT mode by pressing the mode selection button in the remote control.
The BT indication will appear on the LED display
2. Place both devices not more than three feet away from each other.
3. Enable the Bluetooth
function on your audio device and set it to discover the
®
wireless soundbar.
4. The BT icon will start blinking to indicate that the system has entered into the
pairing mode.
5. Once the soundbar appears listed under the newly found Bluetooth
(KSB-001), the pairing process will start.
6. If pairing is successful, the voice prompt "Bluetooth connected" will be heard.
7.If after 60 seconds the pairing process fails, please repeat steps 1 through 6
described above.
device
®
on the side panel
(BT) is the selected mode by default. Or
®
®
Troubleshooting
- The unit is not turning on. Check and make sure the power cord is connected
correctly to the power source.
- There is no sound coming from the soundbar, or the sound is distorted. Make
sure the audio cable is connected correctly. Turn up the volume slowly. Press
the mute button in case it was pressed accidentally muting the soundbar.
- The remote control doesn't work. Install two AAA batteries in the remote.
Replace the current batteries with new ones. Point the remote control toward
the front of the soundbar; and make sure it is within the operating range.
- The buttons on the soundbar don't work. Unplug the soundbar, plug it to a
power supply and turn it on again.
devices
Publicidad
